Calibration&Replacement
How to Replace the RF Tube
Preface: This article describes only the procedure for replacing an RF tube. It does not include calibration. Quick Start Video: Complete Guide: The work performed should be done with the power off and the machine unplugged from the wall. Be sure to ...
How to Replace Controller for Thunder Bolt
Preface: Switch off the machine and unplug it from the wall before starting replacement. Detailed steps: 1. How to save the parameters of the old controller If you can't communicate the old controller, you need a controller, please skip to STEP 2. a. ...
How to Replace USB Expansion Board for Thunder Bolt
Preface: Switch off the machine and unplug it from the wall before starting replacement. Detailed steps： 1. Finding the USB Expansion Board First Bolt Interface Board Location Bolt USB Expansion Board Location It is located on the right side of the ...
How to Replace Thunder Bolt or Odin's X and Y driver
Preface: This article covers how to uninstall and install a driver for the Bolt and Odin series machines. The information here can also be used to swap the X and Y driver with each other for troubleshooting. Quickstart Video: Complete Guide This ...
How to Adjust Thunder Bolt's the Laser Beam Path
Quickstart video： Still need help? For specific technical questions or help requests, please open a Ticket with a picture or video, so our Support team can assist you ASAP. For the information provided in the ticket, please refer to this link： Help ...
Cleaning Thunder Bolt's exhaust fan
Qucikly Video: Specific steps: 1.Use a Phillips screwdriver to loosen both screws, but do not completely loosen the entire screw. 2.Push the hose clamp inward. 3.Then pull out the whole exhaust fan for cleaning. Since the power cord of the exhaust ...
How to calibrate when the touch panel is unresponsive
Problem describe:1.The position of the click in the touch panel is not the same as the position of the panel response. 2.Touch panel does not respond. How to enter the calibration interface: Machine before July 12th,2023: There is a 'Screen ...
Odin/Bolt Laser head assembly diagram
Touch Panel's controller and HMI firmware upgrade method
Firmware Method File Name HMI By Panel update-20231014.hmt Controller By Panel or RDWorks RDC6442G-1G-LY-V7.07.02.20231012.6.upd NOTE:To update the required firmware files, please contact us: tech@thunderlaser.com. The HMI firmware must be updated ...
Camera Calibration for Thunder Bolt
How to import Camera Correction File Every Thunder Bolt has a camera and also have a calibration file. Directly import the calibration file and the camera can be used. How to calibrate the camera Tools needed:A 3mm plywood of 400X300mm; Some magnets； ...