Operation & Features
Titan - Taking the Laser machine apart to fit through a 30" doorway
⚠ STOP — READ BEFORE PROCEEDING The upper section of a TITAN machine is heavy and contains precision laser components. Mishandling it can cause serious injury or permanent damage. The TITAN contains an RF tube, and the TITAN Pro contains both an RF ...
Titan: External Device Control - Air Pump, Exhaust and vacuum table
Quickstart Video Complete Guide: The Titan has the ability to control machine peripherals from the touchscreen with the ability to turn them on manually as well as set the start and stop delays. The general functions are as follows: Start delay ...
How to Change the Name of the Titan Movable Camera
Preface If the Camera cannot communicate with the machine after power-on, you can use the camera preview function to check. If the camera name is recognized incorrectly or shows the same name for two cameras, please first refer to this article to ...
How to Properly Install the TITAN Laser Head to Avoid Scratching the Machine's Sheet Metal
Preface This article explains the correct installation direction of the TITAN laser head to prevent the machine's sheet metal from being scratched due to inertia during homing. Lens Tube Installation Guide: The correct laser head installation ...
How to Test Focus Distance on Titan and Titan Pro
Preface This guide explains how to test and confirm the focus distance (focal length) on Titan Series machines. Test results can be saved to the USB drive supplied with the machine. You may perform the test using RDWorks, LaserMaker, or LightBurn ...
Factory Setting For Touch Panel
Preface Firmware released in September 2025 added a function on the touch panel for users to select settings specific to that model. If you need to upgrade to the new firmware, after the upgrade, please check and confirm on the touch panel whether ...
Lens Change For Touch Panel
Preface: Firmware released in December 2025 for Titan added a function on the touch panel for users to select the Auto-Focus value for the optional lenses/barrels. If you need to upgrade to the new firmware, after the upgrade, please check and ...
How to use the Vacuum Adsorption (Hold-down) Function
Preface Enabling this mode closes the top exhaust valve to increase the suction from the bottom exhaust. On that basis, by increasing the coverage rate to over 95%, the Adsorption Platform function is an application that enhances the vacuum hold-down ...
How to Complete the Connection Configuration for the TITAN Top Cover Camera in LightBurn Software(Temporary solution)
Preface This guide will walk you through how to connect the top cover camera of the TITAN series equipment directly to your computer via an extension cable in LightBurn software—serving as a temporary solution to bypass the WiFi board, since ...
How to Use the Pass Through on TITAN and TITAN Pro Series Machines
Preface This article covers how to use the TITAN machine's pass through function. Complete Guide What is the Pass Through used for The pass through allows for oversized objects to fit in the machine. Your Thunder TITAN has a front removable door and ...
External Device Settings for Titan & Bolt Series
Preface The Titan&Bolt series supports the function of setting the start delay and end delay of external exhaust fans and air pumps. It optimizes the engraving effect and ensures operational safety through airflow timing control. The specific ...
How to change and use different laser sources on TITAN PRO
Preface TITAN Pro Serial supports the installation of both Fiber and CO2 laser sources. In laser processing, CO2 lasers(Laser 1) and fiber lasers(Laser 2) are used in combination to enable the processing of multiple materials on the same machine. The ...
How do i change the language of TITAN series HMI if it is Chinese
Quickstart video: Still need help? For specific technical questions or help requests, please open a Ticket with picture or video, so our Support team can assist you ASAP. For the information provided in the ticket, please refer to this link: Help ...