Getting Started & Installation
Example Layouts for Work Space Considerations For Nova and Nova Plus Laser Machines
The drawings a done graphically and may not be to scale. Use the measurements accompanied by arrows and devices. You should also allow for working space in front of the machine and for any additional peripherals you add. You should leave room on all ...
Getting Nova Series Machines Through A Standard 30" Doorway
User Created Video: Thunder Video: The Users Guide section will walk you through 6 steps for learning how to disassemble your Nova Note: There’s glass laser tube inside the laser machine, be careful and do not collide with anything when moving. ...
USB connection-RDWorks
1. Connect the laser machine and PC with the USB cable that came with the machine. 2. Install the software, please install the USB driver first before press "Install". 3. Open RDWorks and test the connection as following: 4. Then you can download the ...
Stock Nova series Air Assist pump
This stock air pump outputs about 5psi at 4.23 cfm. The cali air 8010 can output 90psi at 2.2cfm, for reference The manual is attached below
Ethernet cable connection-RDWorks
How to connect with a Ethernet cable Connect the laser cutter system to desktop or laptop via an Ethernet cable. 1. Configure computer Go to Start >> Control Panel >> Network and Sharing Center, configure the connection for local connection, like ...
How to setup my Nova laser cutter
How to unpack NOVA crate
NOVA35 NOVA51