USB connection-RDWorks
1. Connect the laser machine and PC with the USB cable that came with the machine.
2. Install the software, please install the USB driver first before press "Install".
3. Open RDWorks and test the connection as following:
4. Then you can download the file to laser machine.
If USB connection works incorrect, check according to this link:
Why USB connection is not working-RDWorks
End.
Related Articles
Why USB connection is not working-RDWorks
Reasons: 1. USB cable is loose or faulty Solution: Unplug the USB cable and plug it back, try again. If re-plug the cable, problem still exists. 2. USB driver is not install successfully Before you install the software, please install the USB driver ...How to run several laser machines with one PC via USB cable connection
If there are several USB interfaces with your PC, it’s able for one PC (laser software) to connect with several machines. pc to hub , one port of the hub goes to laser But For USB connection as below, 1. Pc to hub , one port of the hub goes to laser. ...Ethernet cable connection-RDWorks
How to connect with a Ethernet cable Connect the laser cutter system to desktop or laptop via an Ethernet cable. 1. Configure computer Go to Start >> Control Panel >> Network and Sharing Center, configure the connection for local connection, like ...RDWorks plug-in installation instructions
RDWorks plug-in installation instructionsCannot Connect NOVA/Bolt via USB on WIN11 System
Problem Description: After installing the laser software LightBurn or RDWorks, the USB port cannot communicate with the machine. WIN 11 systems are usually accompanied by the following pop-up prompt. Reason： Enabling Memory integrity in WIN11 ...