Getting Nova Series Machines Through A Standard 30" Doorway

Getting Nova Series Machines Through A Standard 30" Doorway


User Created Video:



Thunder Video:



The Users Guide section will walk you through 6 steps for learning how to disassemble your Nova

Note: There’s glass laser tube inside the laser machine, be careful and do not collide with anything when moving.



Please do as following:


1. Remove the front door, the honeycomb table and the blades. (To reduce the weight and make it easier to move)



2.Remove the Tower Alarm Lamp;(take a picture of the wiring before you remove it)


Disconnect the wire from the connector （ 24V4 to green ； 24V5 to red ； 0V3 to black ）

 Newer machines can reference this article to remove the LED Stacklight
How to remove or replace the Stack Light Status Red Green Lamp



3. Fix the top lid.

Remove the bypass door and Crumb tray door. Use tape or Zip ties to secure the lid. Larder machines will only have a single center handle. Loop the tape or zip ties to the cross brace as shown below.

4. Unscrew all the screws that hold the center section of the machine to the Base. There are 8 screws on each side.



5. Move the machine upper part with a dolly rated for weight




6. After moving all the parts to your room, please reassemble them by fix 8 screws on each side.


HERE ARE THE EXTERNAL DIMENSIONS FOR THE NOVA SERIES MACHINES:

Nova Series Machine Dimensions



    • Related Articles

    • Titan Series Getting Started

      ***This article is a work in progress, we are working to complete all the Coming Soon items. If you have a specific question or need, please email us at tech@thunderlaser.com *** Introduction: So you just bought a new Thunder Laser Titan? This guide ...

    • Nova Series User's Manual

      Please see attached: END

    • Nova Plus Series User's Manual

      Please see attached: End.

    • Repacking & Moving Your Thunder

      Gantry Series Much of this can be gleaned from the unpacking process, but we have some best practices for repacking and/or moving the machine. If you need to disassemble the machine, please also reference this article: Getting Nova Series Machines ...

    • Critical Spare Part Recommendations for NOVA and Nova Plus series machines

      This article discusses spare parts needs for your Thunder Laser Nova and Nova Plus machine series, verify all part numbers for your existing part. If your laser is your business and down time is not acceptable while you wait on part deliveries, then ...