Calibration&Replacement

How to adjust the laser beam path
Wed, 26 May, 2021 at 11:01 PM
How to install new laser tube
Wed, 26 May, 2021 at 11:30 PM
How do I replace the Y-axis belt
Y-axis belt replacement and adjustment(Take the right side of the Y axis belt as an example) Tools needed M3 Screwdriver Plier 5.5mm wrench New belt ...
Wed, 14 Jul, 2021 at 11:31 PM
How do I replace the X-axis belt
X-axis belt replacement and adjustment Tools needed M3 Screwdriver Plier 5.5mm wrench New belt A pair of scissors Masking tape Disassemble Tu...
Wed, 14 Jul, 2021 at 11:32 PM
How to remove the honey comb table
The honey comb table needs to be cleaned after using for a period of time, how to remove it for clean, this video is for reference.
Thu, 26 Aug, 2021 at 11:48 PM
How to install the handle
Tool needed Installation Place the handle on the outside of the hole and the screws on the inside of the hole.  Fix the screws by hand firstly. ...
Fri, 4 Jun, 2021 at 3:08 AM
How to add Reverse compensation setting in software
Before you use the laser machine.  Please remove the transparent bag from the front of honey comb plate. The transparent bag has a set of USB flash drive,...
Fri, 4 Jun, 2021 at 3:09 AM
How to calibrate the working table to level
1. Two sides of the working table are not of the same height Turn off the whole machine power, manually pull one of the belts of Z axis so as to adjust ...
Fri, 4 Jun, 2021 at 3:10 AM
How to improve engraving quality in the scan mode of X-swing
The engraving quality working on x_swing is generally worse than x_unilateralism, it usually results in ghosting effect or image offset or bi-directional en...
Mon, 23 Aug, 2021 at 3:23 AM
How to check if the slot switch is faulty
If the L-shape shaft is bent after being hit, how to solve it? 1. Please loose the screw use M2 screwdriver, and make the L-shape switch to straight and i...
Fri, 4 Jun, 2021 at 3:10 AM