Troubleshooting
Thunder Bolt Troubleshooting guide for having an Alarm Messege on the Screen
Preface: Below is a list of warning messages that may appear on the screen of your Thunder Bolt Machine. These messages are important for diagnosing potential issues and ensuring the proper operation of the machine. You can refer to the following to ...
How to replace the Z-axis lead screw on the Thunder Bolt
Tools needed： 1. Allen wrench set × 1 set 2. Steel ruler × 1 pcs 3. Lead screw × 1 pcs 4. Open-end wrench M5 * M8 × 1 pcs 5. Marker × 1 pcs 6. Positioning fixture × 1 pcs Note: A three-dimensional triangular wooden block is used to secure the lead ...
Bolt Series Air Pressure Sensor Warning（Bolt PRO 22/32）
Problem description When click Start, the panel will display an alarm error as follows: Reasons 1. Air pressure below alarm value The air pressure falls below 0.3 psi. Solution： Adjust the air pressure to make it greater than the alarm value. Loosen ...
X-axis not moving at all for Bolt series
Reasons X-axis Limit switch failure Solution： Check the appearance of the limit switch. a. If there is damage to the appearance. For example, if the rocker of the limit switch is bent and damaged, please try to see if it can be repaired. If this ...
Y-axis not moving at all for Bolt series
Reasons Y-axis Limit switch failure Solution： Check the appearance of the limit switch. a. If there is damage to the appearance. For example, if the rocker of the limit switch is bent and damaged, please try to see if it can be repaired. If this ...
Level the honeycomb table on Thunder Bolt
How to adjust the honeycomb table to level Open the front door and remove the drawer. These four screws are used to secure the table holder. Unlock the set screws. During the adjustment process, it is necessary to observe the change in height and to ...
Replacing the Autofocus sensor for Bolt series
Damaged sensor. Replacement steps Here is a video for reference: Bolt AutoFocus Probe Repair and Replacement Turn off the machine. Preparing a tweezers and new sensor for replacement. Unlock the two set screws counterclockwise and remove the focus ...
How do i change the language of Thunder Bolt HMI if it is Chinese
Bolt Single Blowing Channel Description
Preface:1.Since Thunder Bolt doesn't have a dual air assist, there is no high volume air or low volume air, only the difference of whether or not it uses air assist. 2.When using the blowing air, the volume air can be adjusted by twisting this screw. ...