RD Works
Laser cutter has a wrong cutting/engraving size
Reason: Wrong pulse setting of X/Y axis motors Solution: 1. Please draw a 100x100mm square using the cut mode and send to your laser cutter and cut the square. 2. Let’s say the actual size of the square measured is 98x95mm 3. In RDWorks, go File(F)>> ...
Wrong proportions from RDWorks
Reason: "Enable rotate engrave" is enabled. I’d like to cut a Rectangle at 30x30mm, however, it become 30×60.2 in simulation and in laser. Solution: Please make sure “Enable rotate engrave” is not ticked. End
How to import PDF files into RDWorks
1. RDWorks cannot read PDF and open it directly. 2. Use CorelDraw to open/import PDF file firstly. Then save the graphic as DXF file. Like below: 3. Then RDWorks can read the DXF file, Just import the DXF file into RDWorks directly. 4. The ...
Why does the graphic size that imported to RDWorks different from its original size
Reason: If the file being imported is DXF format, the problem maybe the original file and RDWorks have different units. For example, the unit of the original DXF file is “inch”, but in RDWorks, the DXF unit is set as “mm”. When you import the DXF ...
How to setup wireless network connection for Thunderlaser machine
Here's what you'll need: A computer with wireless capability A wireless router An Ethernet cable A Thunder laser system Step: 1. router setup Use the Ethernet cable to connect the wireless router to the Ethernet port on your laser system. Connect the ...
How to run several laser machines with one PC via USB cable connection
If there are several USB interfaces with your PC, it’s able for one PC (laser software) to connect with several machines. pc to hub , one port of the hub goes to laser But For USB connection as below, 1. Pc to hub , one port of the hub goes to laser. ...
How to run several laser machine with one PC via Ethernet cable-RDWorks
If there is an Ethernet hub in your network, it’s able for one PC (laser software) to connect with several machines. But pc will does only communicate with one machine and sending the file into the laser in the same time. 1. Ethernet hub setup PC to ...
Why USB connection is not working-RDWorks
Reasons: 1. USB cable is loose or faulty Solution: Unplug the USB cable and plug it back, try again. If re-plug the cable, problem still exists. 2. USB driver is not install successfully Before you install the software, please install the USB driver ...
USB connection-RDWorks
1. Connect the laser machine and PC with the USB cable that came with the machine. 2. Install the software, please install the USB driver first before press "Install". 3. Open RDWorks and test the connection as following: 4. Then you can download the ...
RDWorks-Scan offset testing
You can download this file to test and adjust the Scan Offset settings.
RDWorks plug-in installation instructions
RDWorks plug-in installation instructions
Ethernet cable connection-RDWorks
How to connect with a Ethernet cable Connect the laser cutter system to desktop or laptop via an Ethernet cable. 1. Configure computer Go to Start >> Control Panel >> Network and Sharing Center, configure the connection for local connection, like ...