Instrcution
Cannot Connect NOVA/Bolt via USB on WIN11 System
Problem Description: After installing the laser software LightBurn or RDWorks, the USB port cannot communicate with the machine. WIN 11 systems are usually accompanied by the following pop-up prompt. Reason： Enabling Memory integrity in WIN11 ...
Thunder Laser Machines Power ON or OFF
Switching the machine on and off correctly is one of the most important aspects of maintaining the machine, which helps to prolong its life. Switching the machine on and off correctly also prevents problems such as failed axis resets and machine ...
LightBurn Material Test
Preface We recommend using LightBurn's material testing feature before engraving or cutting new materials to determine the optimal parameter. At the same time, we have tested some common materials and the following are the recommended parameters for ...
Material Library for Fiber and CO2 Laser
Located below you will find our machines and their associated library. Click the link to download for your machine. Thunder CO2 glass tube parameter library Thunder CO2 RF tube parameter library Thunder Fiber laser tube parameter library Laser safe ...
How to use the chuck rotary for Aurora Series
Please click the link below for the details How to use the Rotary with an AURORA 8 - YouTube Internal and External Jaws of Fiber Rotary (youtube.com) Chuck Rotary Usage Instructions of THUNDER LASER AURORA Fiber Marking Machine (youtube.com) End.
Files transfer failed when sending files
Problem description The laser software shows "File transfer failed" or "Communication Error" when we send the file to the machine. In LightBurn： In RDWorks： If always get a communication error but no other errors, it might be the machine and software ...
Communication Error
Problem description A "Communication Error" occurs when sending the file to the machine. Which means the machine and software are not connected successfully. In LightBurn： In Lightburn, it will show "File transfer failed". In RDWorks： Reasons 1. The ...
How to adjust the air pressure value of the air pressure detector
The air pressure detector is used to adjust the air pressure value. End.
How to check the quality of the CO2 glass tube by light cone
Testing Tools 15*15*15mm Acrylic. Measurement tools ,tape measure, ruler and so on. Double-sided adhesive. Since 2023-04-08, the toolbox comes with the machine will be equipped with 2×15mm acrylic blocks. Test Method 1. Confirm the power you need to ...
How to delete the memory of the controller
Why we need to delete the memory It will cause a file transfer error if the memory file is full. When the software prompts the following warning, you need to clean up the files in memory. LightBurn： RDWorks： Here is a link to a video for ...
Laser engraving tips-How to hold down warped material
1. When the engraved material is uneven As we work, we are likely to encounter uneven material, which will affect our cutting and engraving results In the case of uneven material： The effect of our engraving may be inconsistent in depth, which is the ...
How to cut smooth acrylics
Introducing how to cut acrylic more smoothly Today we’re going to talk about how to improve your cut smoothness when you’re cutting acrylic and encounter a cut that isn’t smooth. For an even weaker blowing effect, it is recommended to use it with the ...
Thunder laser tips wood cutting
When we use just the right power and speed to cut,there is no excessive charring of the cutting area. As we reduce the cutting speed the charring of the cutting edges deepens. As we increase the cutting power the charring of the cutting area also ...
How to upgrade the firmware
Note: The firmware must be provided by Thunderlaser. Please make sure the software and laser machine are connected before updating. Step1: Step2: Step3: Step4: Choose the firmware we provide. After this step, the software will show that “ Update ...