Why does the cutting and engraving graphics reverse（mirror）

Why does the cutting and engraving graphics reverse（mirror）


Reason:

Improper setting of the software.


Solution:

In RDWorks:

For old versions: Click “Config” – “system setting” on the menu bar. This dialog box will appears.

Make sure “Axis X mirror” is unticked, and “Axis Y Mirror” is must ticked.

 

 

For new versions: Click "Config"-"System setting" -"Configuration" on the menu bar, this dialog box will appears. Make sure the position of "Homing position" and "Laser head" at the left upper corner.


If your setting is different from this, this is the problem why your cutting/engraving reverse. Just reset the config as above.

 

End.


    • Related Articles

    • Engraving problem—The engraving quality is very poor

      Reasons: 1. The needed focus is lost Wrong focus length For standard laser head(2" lens), the focus length is 6mm, 4 inch laser head, the focus length is 10mm. TYPE DOT SIZE FOCAL DISTANCE FUNCTION STANDARD 2" 0.0039″(0.099mm) 4.5mm~6.5mm Cutting ...

    • Rotary axis attachment has a wrong cylindrical engraving/cutting size

      Problem description: The engraving/cutting size is incorrect when you using the rotary attachment.  Reasons: 1. Wrong circle pulse or diameter  (1) Circle pulse Check the gear ratio on your rotary attachment.  Gear ratio 4:1 structure, like below. ...

    • Reverse compensation/Scan offset

      Before you use the laser machine.  Please remove the transparent bag from the front of honey comb plate. The transparent bag has a set of USB flash drive, and an engraving test sample. The USB flash drive stores software, manuals, libraries, etc… ...

    • How to Use Override PWM Frequency to Optimize Cutting and Engraving Quality

      Preface In the world of precision laser processing, "Power" and "Speed" are not the only variables that determine the quality of your work. For users of high-end RF (Radio Frequency) laser tubes, the PWM Frequency is a "secret weapon" that can ...

    • Cutting problem-- Some point of the same piece of materials cannot be cut through

      Reasons: 1. The needed focus is lost Wrong focus length   For standard laser head(2" lens), the focus length is 6mm, 4 inch laser head, the focus length is 10mm. TYPE DOT SIZE FOCAL DISTANCE FUNCTION STANDARD 2" 0.0039″(0.099mm) 4.5mm~6.5mm Cutting ...