Selecting between low and high Dual Air Assist stages in LightBurn

Selecting between low and high Dual Air Assist stages in LightBurn

Selecting Between Low and High Dual Air Assist Stages In LightBurn 


If yours is working backwards please see this article: Thunder Laser Dual-Stage Air Assist Sequencing Issues


    • Related Articles

    • Retrofitting Dual Air Assist

      for Thunder Laser Nova series machines with single air-assist. This is an advanced level installation. Here are all of the resources we have on this: Please see attachment Additional resources: Dual Air Assist Theory of Operation and Schematics How ...

    • Dual Air Assist Theory of operation and schematics

      This is a typical installation of the dual stage air-assist in the Nova series machines. Your configuration may differ slightly. The maximum recommended operating system pressure, according to Thunder China Engineering, is now 40 psi to help prevent ...

    • Dual-stage Air Assist Sequencing issues

      1. Problem description: The machines are equipped with dual air assist have an issue: Set High blow for job and run the job from software, the air assist on the machine is Low assist channel on. But if you run it from machine, it's normal. 2. ...

    • Thunder Laser Dual-Stage Air Assist sequencing issues

      Thunder Lasers with dual-stage air assist systems sometimes experience sequencing issues. This anomaly is predominately occurring when the laser is connected to the PC via USB. If you toggle air assist ON in LightBurn the high volume stage should ...

    • Air-assist error on Odin Series

      Problem description: The machine stops working, and the panel reports Air-assist error. The air pressure value is shown in the figure below. Reasons: 1. The air pressure is too low. If the current air pressure of the machine is lower than the set ...