Lightburn Material Test for All CO2 Glass Tubes

Test with 3mm plywood, LightBurn software,  Engraving(Fill) and Cutting(Line) modes , 60W, 80W, 100W, 130W tubes.

1. Engraving(Fill)
   

60W

80W

100W

130W

1. Cutting(Line)
   

60W

80W

100W

130W

1. Material test file download

The lbrn files are attached

• Related Articles

• LightBurn Material Test

  Preface We recommend using LightBurn's material testing feature before engraving or cutting new materials to determine the optimal parameter. At the same time, we have tested some common materials and the following are the recommended parameters for ...

• Lightburn Material Test for All RF Tubes

  Test with 3mm plywood, LightBurn software，Engraving(Fill) and Cutting(Line) modes, 30W, 55W RF tubes. Engraving(Fill) 30W 55W Cutting(Line) 30W cutting is coming 55W Note: If the circle does not close, it is caused by the minimum power setting being ...

• Aurora 8 material test files download（LightBurn）

  The lbrn files are attached.

• Parameters for CO2 Glass Laser Tube

  You also can check and download this PDF file in the attachment. END

• Material Library for Fiber and CO2 Laser

  Located below you will find our machines and their associated library. Click the link to download for your machine. Thunder CO2 glass tube parameter library Thunder CO2 RF tube parameter library Thunder Fiber laser tube parameter library Laser safe ...