Read this first The Thunder Galvo Series includes the AURORA Series and the Thunder CO₂ Galvo. Driver is very important. Incorrect or uninstalled drivers can prevent the laser software from connecting to the machine. LightBurn and EZCAD_LITE (EZCAD ...
Test with 3mm plywood, LightBurn software，Engraving(Fill) and Cutting(Line) modes, 30W, 55W RF tubes. Engraving(Fill) 30W 55W Cutting(Line) 30W cutting is coming 55W Note: If the circle does not close, it is caused by the minimum power setting being ...
Preface Based on recent R&D testing, Thunder Laser recommends updating the RF tube Pre-Ignition Mode as a preventative maintenance measure. This change is intended to improve the long-term stability and cutting performance of ET Series RF laser ...
Preface This guide will walk you through how to connect the top cover camera of the TITAN series equipment directly to your computer via an extension cable in LightBurn software—serving as a temporary solution to bypass the WiFi board, since ...