How to upgrade the firmware

Note:

The firmware must be provided by Thunderlaser.

Please make sure the software and laser machine are connected before updating.

Step1:

Step2:

Step3:

Step4:

Choose the firmware we provide.

After this step, the software will show that “ Update files download successfully”.

Step 5

Press ”Enter” button on LCD panel, then it update successfully.

End.

• Related Articles

• Touch Panel's controller and HMI firmware upgrade method

  Firmware Method File Name HMI By Panel update-20231014.hmt Controller By Panel or RDWorks RDC6442G-1G-LY-V7.07.02.20231012.6.upd NOTE:To update the required firmware files, please contact us: tech@thunderlaser.com. The HMI firmware must be updated ...

• Dual-stage Air Assist Sequencing issues

  1. Problem description: The machines are equipped with dual air assist have an issue: Set High blow for job and run the job from software, the air assist on the machine is Low assist channel on. But if you run it from machine, it's normal. 2. ...

• How to Replace Controller for Thunder Bolt

  Preface: Switch off the machine and unplug it from the wall before starting replacement. Detailed steps: 1. How to save the parameters of the old controller If you can't communicate the old controller, you need a controller, please skip to STEP 2. a. ...

• Retrofitting Dual Air Assist

  for Thunder Laser Nova series machines with single air-assist. This is an advanced level installation. Here are all of the resources we have on this: Please see attachment Additional resources: Dual Air Assist Theory of Operation and Schematics How ...

• How to choose software after controller update

  RDWorks for different controller Software Controller RDWorksV8.01.60 and older version RDC6442G-LY-B RDWorksV8.01.62 and latest version RDC6442G-LY-B AND RDC6442G-LY-1G A software installation package is in U-disk that came with the machine. If you ...