How to measure the laser tube power with a power meter

Please don't put the power meter under the laser head to test, here is the demonstration of the error.

• Related Articles

• Why the laser tube won’t fire the beam

  Problem description: The laser tube won't fire the beam even the laser switch is on. Reasons: 1. The laser beam path is out of aligned If the laser beam path is out of aligned, the beam cannot comes out from laser head. Solution: Paste a piece of ...

• Laser water coolants & additives

  Overview There has been much debate, experimentation, and documentation on the subject of water cooled lasers with regards to the main cooling fluid and additive combinations. The theoretical, as well as practical, implementations and observations ...

• Power Alarm on AURORA 8 PRO（50QB）

  The issue usually occurs on AURORA 8 PRO（50QB）.If you have the same problem with other AURORA models, please contact us:tech@thunderlaser.com Problem describe Ezcad 3 show error" Power alarm" Reasons： 1. Unstable voltage with laser source Solution： ...

• Test the power of RF Tube

  Preface This article is about how to use a power meter to check the power of an RF tube. Tools required 1. Tools Power Meter， People *2 Quick Video Specific inspection steps 1. Please open the door on the left side, find this small board, and press ...

• Parameters for RF Laser Tube

  Please see attached END