How to install CCD camera driver manually
Problem:
If the SV300 model has been selected during the installation of RDWorks and the installation of the driver has been completed, it is still not possible to connect to the CCD camera.
①The machine's camera can be recognised:
②The machine's camera can't be recognised:
Solution:
Manual installation of CCD camera drivers.
Before installing the driver, make sure to close the RDWorks first .
- You can find the manual installer here:
https://drive.google.com/drive/folders/125FsWP47MaznyBXIqPHq7JWgFo2YCc5z
- Initiate the driver process.
- Be sure to tick all drivers to be removed before uninstalling.
4. Be sure to tick all drivers to be installed before installing them.
5. Conclude by finishing the driver installation.
6. Finally open RDWorks again, use the camera and check for a successful connection.
Still need help?
For specific technical questions or help requests, please open a Ticket with picture or video, so our Support team can assist you ASAP.
For the information provided in the ticket, please refer to this link：
End.
Related Articles
Installation and Usage of CCD Camera
Installation: Usage: Software： Please download it from our official website. Downloads | THUNDER LASER The unzip password is 123456. Driver： Please refer to this link article.How to install CCD camera driver manually Still need help? For specific ...How to install driver for Ezcad3
Installation steps: The dongle must be plugged into the computer during the installation process. 1. Connect your fiber laser with PC through USB cable. 2. Open manage on your computer. 3. Find the devices (DLC10000) with exclamation marks in device ...How to Choose the Correct Driver for Ezcad2
Problem description When the following problems are encountered during the installation of the driver 1. The error message appears: "Windows has found drivers for the device, but encountered an error while trying to install them." 2. If the driver is ...How to Replace Thunder Bolt or Odin's X and Y driver
Preface: This article covers how to uninstall and install a driver for the Bolt and Odin series machines. The information here can also be used to swap the X and Y driver with each other for troubleshooting. Quickstart Video: Complete Guide This ...How to install and calibrate the lightburn camera