How to adjust the air pressure value of the air pressure detector

The air pressure detector is used to adjust the air pressure value.

End.

• Related Articles

• Air Pressure Sensor Setup Procedure

  Air Pressure Detector Settings Yihd Airtac SMC Model WEW02-N-KHR DPSN1-10020 ISE20-N-M-L Lock&Unlock Press and hold the SET key and ∨ keys simultaneously to lock or unlock / Press and hold the SET key for 6 seconds, ignoring the SET interface at 2 ...

• Air-assist error on Odin Series

  Problem description: The machine stops working, and the panel reports Air-assist error. The air pressure value is shown in the figure below. Reasons: 1. The air pressure is too low. If the current air pressure of the machine is lower than the set ...

• Bolt Series Air Pressure Sensor Warning（Bolt PRO 22/32）

  Problem description When click Start, the panel will display an alarm error as follows: Reasons 1. Air pressure below alarm value The air pressure falls below 0.3 psi. Solution： Adjust the air pressure to make it greater than the alarm value. Loosen ...

• Retrofitting Dual Air Assist

  for Thunder Laser Nova series machines with single air-assist. This is an advanced level installation. Here are all of the resources we have on this: Please see attachment Additional resources: Dual Air Assist Theory of Operation and Schematics How ...

• Stock Nova series Air Assist pump

  This stock air pump outputs about 5psi at 4.23 cfm. The cali air 8010 can output 90psi at 2.2cfm, for reference  The manual is attached below