EzCad3 Activation Error Code 284

EzCad3 Activation Error Code 284

Problem description：

Open LicenseManager and fill in the activation code, then click Activate, the software prompts an error warning as follows:


Reason

Incorrect activation code or incorrect activation code format.

The activation code is made up of 16 digits of numbers and English.

Solution

Fill in the correct activation code.

  1. Find the dongle and fill it out according to the label information.
    Open the side door of the machine and find the dongle on the USB expansion board, but make sure it is plugged into the expansion board when you activate it!


  2. Find the TXT and PNG file information on the U-disk and fill them in.
    File path: U-disk that came with machine>AURORA 8 PRO>Fiber software>Serial number of dongle


If the above methods do not solve your problem, please contact us: tech@thunderlaser.com


End.


    • Related Articles

    • Connecting an Aurora to EzCad/Lightburn

      Read this first Driver is very important. Incorrect or uninstalled drivers can prevent the laser software from connecting to the machine. LightBurn and EzCad2 drivers cannot be installed on the same computer at the same time, only one of them can be ...

    • Troubleshooting Guide for LaserMaker 2.0 License Key Activation Failure

      Preface This guide helps resolve license activation failures in LaserMaker 2.0. For persistent problems, contact support with your version and error details. Phenomenon When attempting to activate LaserMaker using the license key, a "License ...

    • Power Alarm on AURORA 8 PRO（50QB）

      The issue usually occurs on AURORA 8 PRO（50QB）.If you have the same problem with other AURORA models, please contact us:tech@thunderlaser.com Problem describe Ezcad 3 show error" Power alarm" Reasons： 1. Unstable voltage with laser source Solution： ...

    • How to use EZCAD Code Bar

    • Communication Error

      Problem description A "Communication Error" occurs when sending the file to the machine. Which means the machine and software are not connected successfully. In LightBurn： In Lightburn, it will show "File transfer failed". In RDWorks： Reasons 1. The ...