Exhaust fan cannot extract smoke or dust
Reasons:
1. Exhaust fan break down
Solution:
there’s a common way to connect it to the power directly using the power cable of chiller, then check if exhaust fan can be turn on normally. See below.
2. Connect the fan inlet and outlet in opposite directions
Solution:
Please check if the exhaust fan install incorrectly.
3. Exhaust channel are blocked
Solution:
Clean them to make sure the the exhaust channel is in good condition.
End
Related Articles
Cleaning Thunder Bolt's exhaust fan
Qucikly Video: Specific steps: 1.Use a Phillips screwdriver to loosen both screws, but do not completely loosen the entire screw. 2.Push the hose clamp inward. 3.Then pull out the whole exhaust fan for cleaning. Since the power cord of the exhaust ...Cleaning your stock exhaust fan
This is what can build up in your exhaust system, especially the fan, and can cause critical failure so its important to regularly maintain your exhaust system. Here is how to clean the HF-150 Inline Fan that ships with the Mini 60 and Nova 24: Here ...Instruction Exhaust Fan Manuals For THUNDER LASER
Simple information about the Exhaust Fan on the THUNDER LASER machine. Machine Series Model of Machine Model of Exhaust Fan Diameter of Exhaust Duct NOVA Series NOVA24 & 35 Ver 2.0 / Ver 2.5 / Plus HF-150PE 150mm NOVA51 & 63 Ver 2.0 / Ver 2.5 / Plus ...How to Improve Cutting Result and Reduce Edge Carbonization on Your Thunder Laser Machine
Preface Edge charring, yellowing, or severe carbonization during laser cutting is one of the most common and troublesome issues, particularly when cutting wood, plywood, acrylic, and other organic materials. This occurs when the material is exposed ...Thunder Air Series User's Manual
Please see attached. Still need help? For specific technical questions or help requests, please open a Ticket with picture or video, so our Support team can assist you ASAP. For the information provided in the ticket, please refer to this link： Help ...