Determining Zero Focus for Metal Laser Cutting

Determining Zero Focus for Metal Laser Cutting

Preface

This article explains how to determine the zero-focus position for metal laser cutting and use it as a reference for setting the cut focus. The procedure compares test cuts made at different focus settings to identify the position at which the laser focal point coincides with the sheet surface. Establishing this reference helps operators set the cut focus accurately when adjusting cutting parameters for different materials and sheet thicknesses.


Note: The zero-focus position is normally calibrated at the factory. Setting Cut Focus to 0 in the software's layer parameters places the focal point on the material surface. If there is a slight deviation, follow the procedure below to determine the actual zero-focus position.

1.Understanding Zero Focus

Zero focus occurs when the laser focus lies exactly on the top surface of the workpiece.

This guide uses the following sign convention:

  • Positive focal position (+): The focus is above the workpiece surface.
  • Zero focal position (0): The focus is on the workpiece surface.
  • Negative focal position (−): The focus is below the workpiece surface.

2.Determining Zero Focus

Step 1 Use NC Studio to Create the Test Pattern

Draw a straight line 100 mm long in the NC Studio.

Create an array containing 13 parallel lines in total, and assign each line to a separate process layer.

Step 2 Assign the Focus Settings

Keep all other parameters unchanged and assign the following cut focus setting to the 13 lines:

+3.0, +2.5, +2.0, +1.5, +1.0, +0.5, 0, −0.5, −1.0, −1.5, −2.0, −2.5, and −3.0 mm.

Note: Maintain the same nozzle standoff distance throughout the test. Changes in nozzle height may affect the actual focal position relative to the workpiece surface.

Step 3 Cut the Test Lines

Cut the lines in a 1 mm thick stainless steel sheet, using compressed air as the assist gas.

Use suitable cutting parameters for the test material, and vary only the focus setting.

Step 4 Compare the Kerf Widths

Inspect the resulting kerfs and compare their widths under otherwise identical test conditions.

The setting that produces the narrowest kerf provides an estimate of the zero focal position.

As shown in the figure below, the narrowest kerf is obtained when Cut focus is set to 0.5 mm. Therefore, the zero-focus position of the machine is determined to be 0.5 mm.

3.Using Zero Focus to Set the Cut Focus

When optimizing cutting parameters, negative focus is generally used to achieve the required cut quality. The cut focus is typically positioned at or slightly below the mid-thickness of the sheet. For example, for a 20 mm thick carbon steel sheet, the cut focus should be slightly more than 10 mm below the surface. First determine the zero-focus position, which provides the reference for setting the required cut focus.

Negative-focus cutting offers greater stability during extended operation, is less sensitive to variations in the sheet material, and can improve cut quality. Its cutting speed is approximately twice that of positive-focus cutting, and the nozzle is less prone to overheating.

Calculate the required cut focus setting using the following relationship:

Required cut focus setting = target focus offset + zero-focus setting

For example, assume that the zero-focus setting is +0.5 mm. To cut a 20 mm thick carbon steel sheet with the cut focus 12 mm below the surface, the target focus offset is −12 mm.

The required setting is therefore:

−12 mm + 0.5 mm = −11.5 mmSet the cut focus to −11.5 mm.

Note: This example illustrates the calculation only. It is not a recommended cutting parameter for all 20 mm carbon steel plates.