An error "cannot open correct file" when running EzCad2 or 3
Problem describe:
The software show "cannot open correct file"!
Reason:
Ezcad2 or 3 use the correction file, but the correction file path is incorrect.
Solutions:
① If your software is EzCad2.
Open the param (F3).
Select the correct correction file according to the field lens.
You can find the correction file under this path:
U-disk came with the machine >> AURORA Series - Fiber Laser >> Aurora 8 >> Fiber software >> correction file
② If your software is EzCad3.
Open the param(F3)
Select the correct correction file according to the field lens.
You can find the correction file under this path:
U-disk came with the machine >> AURORA Series - Fiber Laser >> Aurora 8 PRO >> Fiber software >> correction file
End.
Related Articles
Connecting an Aurora to EzCad/Lightburn
Read this first Driver is very important. Incorrect or uninstalled drivers can prevent the laser software from connecting to the machine. LightBurn and EzCad2 drivers cannot be installed on the same computer at the same time, only one of them can be ...How to Choose the Correct Driver for Ezcad2
Problem description When the following problems are encountered during the installation of the driver 1. The error message appears: "Windows has found drivers for the device, but encountered an error while trying to install them." 2. If the driver is ...Power Alarm on AURORA 8 PRO（50QB）
The issue usually occurs on AURORA 8 PRO（50QB）.If you have the same problem with other AURORA models, please contact us:tech@thunderlaser.com Problem describe Ezcad 3 show error" Power alarm" Reasons： 1. Unstable voltage with laser source Solution： ...EzCad3 Activation Error Code 284
Problem description： Open LicenseManager and fill in the activation code, then click Activate, the software prompts an error warning as follows: Reason Incorrect activation code or incorrect activation code format. The activation code is made up of ...Communication Error
Problem description A "Communication Error" occurs when sending the file to the machine. Which means the machine and software are not connected successfully. In LightBurn： In Lightburn, it will show "File transfer failed". In RDWorks： Reasons 1. The ...